BBSHD Motor Protectors

 I wanted to protect my motor (and the trail) from my pilot error and from rocks and debri thrown from the front tire.

I first tried some rubber but that stuck to the trail and rocks which elevated the possibility of moving the motor on a hard impact.

After much testing I ended up with a flexible TPU material that is a little more on the firm side with great abrasion qualities.

(it slides!)

 

First I did a Full Cover, then fully Vented and finally a DH Skidplate design.  My personal Goldilocks style.

They all fit on BBSHD motors by replacing the housing bolts on both sides with longer ones.

No need for some ugly zip tie or hose clamp. Looks like it was meant to be there.

 

They worked better than I could have imaged on testing!

On one test I skied over a big rock and it hardly slowed me down.

May you never know the anguish of trying to bash your motor on rocks…

This is not recommended nor should it be done on purpose!

This is designed as a safety measure only.

DH Skid Plate

Full Cover

Max Vent

EASY INSTALLATION

Simple as Replacing
6 Motor Bolts!
(included)

Start at one end. Replace both bolts.

Then middle bolts.

Install last two and tighten.